6
□40
3
4.
1
⌀12 H8
M8
36
36
8.
4
4
M6
4
On longer stretches, when the support profiles have already been installed
or are being held in a vice and the Shaft-Clamp Profile has been pressed into
place, you can press the shaft into the Shaft-Clamp Profile section by section
using the Mounting Aid (0.0.265.38) and a lever in the form of a suitable
round steel bar.
When higher loads are involved, it is advisable to secure the Shaft. Ideally, a
Combination Drilling Jig (c) should be used to machine the Shaft, Shaft-Clamp
Profile and Support Profile as detailed in the following steps:
▪
Using a carbide drill, cut a blind hole in the Shaft, 40 mm from the end face
(as shown in the drawing)
▪At the same distance from the end face, cut a through hole (d) through the
Shaft-Clamp Profile and Support Profile together, up to the centre bore of
the Support Profile
▪Press dowel pin (b) DIN 6325 into the Shaft
▪
Install the Shaft into the Shaft-Clamp Profile as described above
Installation
b = DIN 6325-6x30 dowel pin
c = Order No. 0.0.373.55 for Shaft D14
d = ⌀6 mm
Carriage Profile
Grub screw
Adjuster Profile
Double-Bearing Unit
End Cap and Lubricating System
Shaft-Clamp Profile and Shaft:
There are various methods for assembling support profile, Shaft-Clamp Profile
and Shaft.
To make installation easier, apply a film of oil or grease to the outer surfaces of
the Shaft-Clamp Profile that come into contact with the support profile before
pressing it into the groove. Do the same to the contact points between the
Shaft and Shaft-Clamp Profile and to the guiding Shaft itself. When working
with short support profiles that have not yet been connected to a fixture, it is
advantageous to undertake installation in the following steps:
▪
Press the Shaft-Clamp Profile into the relevant groove of the support profile
▪Use a vice (fitted with protective jaw plates) to press in the Shaft
▪
Follow the same sequence for the other side
Slide LRF 8 D14 160x160/200x160
Once the support profile has been machined, prepared and connected with the
Shaft-Clamp Profiles, the guide carriage can be slotted into place on it.
Slot the carriage on before fitting the End Cap and Lubricating System (or
remove the latter first).
The LRF guide carriages in the various sizes as appropriate to the width of the
support profile are partially assembled. One Double-Bearing Unit is preassembled
ready for use, screwed firmly into place and cannot be adjusted. The other
Double-Bearing Unit is supplied with adjustment screws on the side that
protrude slightly.
