ITEM 0.0.641.21, Notes On Use And Installation

Page: 10 / 12

k
k
min
max
93
80
Ø5
3
22
M
A
F
x
5
5
93
□80
Ø53
10
ƒ The housing of the drive Reverse Unit and the Coupling Housing of the Drive
Set fit together perfectly thanks to their design and a centring disc. Machine
the Coupling Housing of the Drive Set to suit the connection dimensions of
the motor or transmission you are using.
ƒ
To connect the Drive Set to the drive Reverse Unit, remove 4 of the 6 fasten-
ing screws in the drive Reverse Unit and replace them with the longer M6x50
Hexagon Socket Head Cap Screws included with the Drive Set.
ƒ
The M6x50 Hexagon Socket Head Cap Screws are driven through the drive
Reverse Unit into the Coupling Housing of the Drive Set.
ƒ Tightening torque, M6: 10 Nm
ƒ
Bore out the equaliser coupling to match the diameter of the drive shaft of
the motor or transmission you are using and clamp it to the drive shaft in line
with the mounting dimensions below.
k
min
= 42 mm
k
max
= 62 mm
ƒ
Next, insert the drive and coupling into the Coupling Housing of the Drive Set
and connect them to the drive shaft of the drive Reverse Unit through the
Coupling Housing.
Limit-Switch Holder KRF 8
ƒ The Limit-Switch Holder is prepared for fastening to the lower side grooves of
Profile 8 80x40 KRF.
ƒ Optimised for Proximity Switch 8
Proximity Switch 8 1NO, 0.3.001.30 (normally open)
Proximity Switch 8 1NC, 0.0.600.05 (normally closed)
​
Limit-Switch Holder KRF 8 can also be used for position detection on other
item linear slides.