Function
and Features
Copyright ©ITECH Electronic Co., Ltd.
38
The above steps only set entire framework of auto tests. Additional
setting is required for specific parameters in each step. This design will
facilitate modification of parameters in a single step.
16. Select desired working mode and set working parameters. Press
[Shift]
+
[CV]
to enter parameter setting.
10.0000V 0.0000A
0.00W CC=1.000A
17. It is assumed that step 1 edits CC mode as follows: current: 2A, maximum
voltage value: 10V, and minimum voltage value: 2V; and step 2 edits CV
mode as follows: voltage: 3V, maximum current value: 5A, and minimum
current value: 0A. After parameter setting in each step, press
[ESC]
to exit
setting menu. Press
[Shift]
+
4 key for saving.
Settings at each step
should be independently saved. Refer to the Correspondence Table
for saving position.
18. It is necessary to recall test files for running after editing auto test files.
Recall test file for running
To recall edited test files from EEPROM quickly after re-energizing instrument,
refer to the method below.
1. Press
[Shift]
+ 6 keys.
PROGRAM
Run Recall Edit
2. Operate
key, select Recall and press
[Enter]
key.
RECALL PROGRAM
Recall Program File=1
3. Operate
key, select Run and press
[Enter]
key.
PROGRAM
Run Recall Edit
4. Display auto test file 1.
PRG01 STOP
5. Press
[Shift]
+
key.
Operate auto test file 1. Press
[Shift]
+
0 key to pause auto test. Press
key for next step.
