3
E
NGL
IS
H
17.
DO NOT USE THE TOOL IF THE SWITCH DOES NOT TURN IT ON OR OFF.
Any tool that cannot be
controlled with the switch is dangerous and must be repaired.
18.
DISCONNNECT THE PLUG FROM THE POWER SOURCE BEFORE MAKING ANY ADJUSTMENTS,
changing accessories, or storing the tool. Such preventive measures reduce the risk of starting the tool
accidentally
19.
STORE IDLE TOOLS OUT OF REACH
of children and other untrained persons. Tools are dangerous in the
hands of untrained users.
20.
MAINTAIN TOOLS WITH CARE.
Keep cutting tools sharp and clean. Properly maintained tools with sharp
cutting edges are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged tools,
“Do not use” until repaired.
21.
CHECK FOR MISALIGNMENT OR BINDING OF MOVING PARTS, BREAKAGE OF PARTS
, and
any other conditions that may affect the tool’s operation. If damaged, have the tool serviced before using.
Many accidents are caused by poorly maintained tools.
22.
USE ONLY ACCESSORIES THAT ARE RECOMMENDED BY THE MANUFACTURER
for your model.
Accessories that may be suitable for one tool become hazardous when used on another tool.
SERVICE
23.
TOOL SERVICE MUST BE PERFORMED BY QUALIFIED REPAIR PERSONNEL
at an authorized service
centre. Service or maintenance performed by unqualified personnel could result in a risk of injury.
24.
WHEN SERVICING A TOOL USE ONLY IDENTICAL REPLACEMENT PARTS
. Follow instructions in the
maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance instructions
may create a risk of electric shock or injury.
ADDITIONAL SAFETY REGULATIONS
1. When the machine is in operation, keep hands away from the cutting or grinding area.
2. The disc will not stop immediately the machine is turned off. Exercise caution.
3. Do not place the tool down after use until the grinding or cutting wheel has come to complete stop.
4. Do not start the tool when the grinding or cutting wheel is touching the work piece.
5. Always ensure the safety guard is attached correctly and do not operate the angle grinder without
the guard attached.
6. Only use grinding and cutting wheels that are approved for a maximum speed of 12,000 RPM or greater.
7. Only use grinding or cutting wheels with the correct bore size for the spindle of the grinder.
8. Keep the power cord well away from the cutting area during use. Always position the cord so that it will
not be caught in the workpiece when the grinder is in use.
9. Always wear earmuffs, safety glasses and face mask while in operation.
10. Before connecting the tool to the power supply, follow the safety instructions to install the grinding or
cutting wheels. Do not lock the wheel too tight, or cracks may occur.
11. Always use both hands when operating the tool.
12. Use the supplied standard parts. Do not use a coolant or water and do not use as a fixed grinder.
13.
ENSURE THE EXTENSION CORD YOU USE IS OF SUFFICIENT GAUGE FOR ITS LENGTH.
RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS
Amps from
Tool Nameplate
25' long
50' long
75' long
100' long
150' long
200' long
0 - 5 amps
16 ga.
16 ga.
16 ga.
14 ga.
12 ga.
12 ga.
5.1 - 8 amps
16 ga.
16 ga.
14 ga.
12 ga.
10 ga.
Do Not Use
8.1 - 12 amps
14 ga.
14 ga.
12 ga.
10 ga.
Do Not Use
Do Not Use
12.1 - 15 amps
12 ga.
12 ga.
10 ga.
10 ga.
Do Not Use
Do Not Use
15.1 - 20 amps
10 ga.
10 ga.
10 ga.
Do Not Use
Do Not Use
Do Not Use
IMPORTANT SAFETY INSTRUCTIONS
