!
GB
PLEASE READ THIS INSTRUCTION LEAFLET CAREFULLY
THROUGH BEFORE INSTALLING AND OPERATING THE DEVICE.
2. SAFETY REGULATIONS
To avoid shocks and fire risks, read and follow closely the
following instructions:
•
Always unplug the device from the mains before carrying out
any work on it.
•
Be sure that the electric line connecting the device to the
mains and the extension leads have a cross-section suitable
for pump power and be sure that the electrical connections
are far away from any water source.
•
When Fluomac is used for swimming pools, ponds and
fountains it is necessary to use an automatic RCD with
IDn=30mA protection.
WARNING: when the pump stops the pipes are under pressure
consequently we recommend opening a tap to discharge the
system before carrying out any work.
3. INSTALLATION
1.
Install Fluomac anywhere between the pump and the first service
outlet so that the arrow on the case is pointing in the same
direction as the fluid flowing through the pipe. Check perfect water
tightness of all water connections. If you are using a pump with a
pressure higher than 10 bar, install a pressure reducer on the
Fluomac’s inlet.
2.
For the electrical connection of the version supplied without
electric leads, follow the wiring diagram on the printed circuit board
cover. Furthermore, in case of use of a pump with power higher
than ½ Hp and the ambient temperature is higher than 25° C it is
necessary to wire Fluomac with cables with a thermic resistance
not inferior to 99°C.Use only suitable wire nippers to wire the
Fastons. If the leads are included, simply connect the pump’s
power plug to the Fluomac socket and its own power plug to a
current outlet.