7
Installation guide
Local Control Network - building controls in perfection
LCN-ULT
transferred to the I-port from now on.
Note:
Even if authorizations and function mappings for ID numbers are still being registered in
the LCN module, all transponders of this erased type, will no longer be sent from the
Transponder reader and not be transffered to the LCN Bus from this LCN-ULT.
Erasing all transponder types / condition on delivery
This function will erase the complete type storage and resets the LCN-ULT into the factory
settings. The master card has to be held in front of the transponder reader for longer than
15 seconds. When the master card is recognised, the LED will flash in blue. After about 5
seconds it will flash slowly in red. After a further 10 seconds the slow flashing red will
change to a fast flashing red. The fast flashing indicates that the transponder reader mode
has changed to “preparing to ERASE ALL” . Should the complete type storage not have to
be erased, then please remove the master card and wait until the blue LED lights
permanenty again.
To carry out the removal of the complete type storage, the master card is held further
until the LED switches off completely. The switching off of the LED is an indication, that
whole type storage in the LCN-ULT has been erased (factory settings). After
completion, the LED lights up again permanently.
®
