Installation guide
Local Control Network - building controls in perfection
4
Attaching the reading head
Please make sure when tightening both of the screws with the supplied tool, that the
tightening torque isn´t too high. This applies especially when using an electrical screwdiver.
Too much force can damage the plastic housing!
Usage in or on metal surfaces
The opening in the metal surfaces should be at least 60 mm, otherwise the metal could
reduce the reception range drastically. In some cases the reading function can be
completely distorted.
A damage to the system is not possible through this, the LCN-ULT recognises such
influences and reduces the transmitting power automatically.
When a distinctive range reduction occurs, please try the function with the reading head
away form its fixing point. should the required reading range then be achieved, simply
increase the distance to the surrounding metal surfaces.
Preparing for operation / learning new transponder types with an LCN-ULT
The ready to use reading head lights up blue permanently. When first delivered, the LCN-
ULT will not recognise any transponders. When the master card is held shortly in front of the
reader, the LED will flash slowly in blue. Remove the master card after this, the “learn
mode”- is activated. Now the chosen transponder or car key is held in front of the reader,
until the blue LED light stops flashing and lights up permanently again. Through this, the
LCN-ULT
®
