Isotra ZIP ECO Measurement And Assembly Manual Download Page 6

Page: 6 / 10

MEASUREMENT AND ASSEMBLY MANUAL

Manual validity: 01.02.2015

Once the installation is finished, check whether the guide rails are parallel and right-angled. This can

be done by measuring two distances “S1” and “S2” or diameters “D1” and “D2”. The dimensions must

be equal ± 2 mm. Proper placement of the guide rails is necessary, otherwise the function of the roller

blind will be affected. In case of front installation of the guide rail, self-sticking caps are supplied to

cover the fastening screw holes.

7. WIRING OF THE SCREEN ZIP ECO ROLLER BLIND

Attach the motor switch (of the type requiring the presence of operating staff) to a wall. The switch must be installed in a

position providing to the user unobstructed view of the moving roller blind. Observe instructions indicated in the installation

instructions for the motor supplied with this manual.

All wiring must be made in accordance with valid IEC standards. Use impulse switches together with the control unit in all

situations where there is more than one device to control the same roller blind. The control unit will store the provided

impulse for approx. 3 minutes or until receiving another command.

NOTE: In order to have the installation correspond to international standards, a safety cut-off device having the

contact opening distance of at least 3 mm must be installed in front of the circuit.

In case of installation of several roller blinds with group controls, where the user cannot see all the windows, adopt all

measures to prevent that any persons or objects obstruct the movement of the roller blinds.



Do not connect two or more motors to the same control unit without using a group control unit. Do not use light

switches. Do not connect two or more switches to the same motor.



Do not use switches with blocking without a control unit for group control, otherwise there is a risk of a duplicate

command with consequent motor short-circuiting.



Any damage caused by failure to comply with the above instructions shall not be attributed to the manufacturer

and

shall lead to a loss of guarantee

Summary of Contents for ZIP ECO










