MEASUREMENT AND ASSEMBLY MANUAL
Manual validity: 01.02.2015
5
INSTALLATION OF GUIDE RAILS
Proper method of installation of guide rails to the box depends on the box model used.
The guide rails are supporting elements of the while system.
Only one model of guide rails
– type A30 – is available for the ZIP ECO.
The rail is supplied with pre-drilled holes, always from the front.
The holes are arranged as follows:
Outer holes are located approx. 15 cm from the rail edge;
Intermediate holes are located evenly and spaced 50
–80 cm along the guide rail length.
A)
B)
The ZIP ECO guide rails consist of two parts: the basic supporting bar and the plastic inner rail in which the zipper moves.
A) Aluminium guide rail;
B) Plastic guide rail.
1.
Insert the guide rails in the side piece mandrel, check if height of the guide rails is the same.
2. Cut the plastic guide rail to size, with the edge perfectly right-angled. After cutting the inner plastic rail, both upper
edges of the profile should be bevelled as shown above, to prevent rubbing of the fabric against the sharp edge during
the use.
3. Insert the plastic guide rail B) from below and close the profile with the metallic plug of the guide rail.
4. Place the whole roller blind with the guide rails to the place of intended installation.
5. Indicate the drilling points where the roller blind will be attached by screws (size according to the wall material and
screws used).
6. Attach the guide rails to the wall (frame) using screws suitable for the underlying structure (metallic frame, cement,
brick, etc.).