Page 6 of 44
TTI-7 Iss.02 – 06/11
OPERATING INSTRUCTIONS: SOFTWARE VERSION 7.1
SUPPLIED ACCESSORIES
1 Mains Cord
1 RS 232 Cable
1 Operating Instructions (English)
When unpacked, inspect for physical damage and report any defects immediately in writing, retaining packaging
materials for inspection. Before placing into service, ensure mains voltage is correct. Instruments are normally
supplied for 240Volts 50Hz. Other voltages may also be selected according to the chart in the Maintenance section.
Be sure to also change the fuse to the correct type and rating.
SAFETY
This apparatus is designated Safety class 1 as defined in the IEC publication 1010-1 (Amendment 1).
CE MARKING
This apparatus complies with the CE marking directive, 93/68/EEC, and is in compliance with the following standards:
Generic Emission Standard
EN5081-1
Conducted Emissions
EN55022 Class B
Radiated Emissions
EN55022 Class B
Generic Immunity Standard
EN5082-1
Conducted Immunity (Power Lines)
prEN60 1000-4-4 1kV
Conducted Immunity (Signal Lines)
prEN60 1000-4-4 500V
Radiated Immunity
prEN60 1000-4-3 3V/m
Electrostatic Discharge Immunity
prEN60 1000-4-2 8kV
Electrical Safety Standard
IEC1010-1 (Amend 1)
INSTALLATION
The TTI 7
PLUS
is designed to be either free bench-standing, or rack-mounted. The TTI 7
PLUS
is ½19", 2.5U high.
When connected to a mains supply, the mains cord provided with the equipment should be used, and connected only
to a mains supply with a suitable earth connection. Before connection to the mains supply ensure that the correct
voltage is set, and the fuse is of the correct rating.
MAINTENANCE
Normally no maintenance is required other than cleaning with a moist cloth. Avoid aggressive detergents or solvents.
CAUTION: Before any maintenance, repair, or exchange of parts or fuses, the instrument must be disconnected
from the mains supply and all other power sources. In the event of a fault occurring, the instrument should be
returned to our factory, or Agent, for rectification. A mains fuse is fitted to the mains inlet socket on the rear panel,
and should be replaced if necessary. The Instrument should only be serviced/repaired by a competent engineer and
only design approved replacement parts used.
