isobus CCI A3, Operating Instructions Manual

Page: 29 / 32

27
Listed below are some of the problems that may occur during use of the
CCI A3. A suggestion is made for rectification for each problem.
Try to rectify the problem.
Contact your dealer if you cannot resolve the problem.
Problem Cause/remedy
The CCI A3 does not
switch off, if you switch off
the tractor ignition.
The tractor does not switch off the supply to the in-cab
panel connector.
Unplug the in-cab coupling of the cable from the in-cab
panel connector of the tractor.
The operating screen of
the CCI A3 is not dis-
played on the terminal .
The terminal is switched on and connected to the ISOBUS,
however the UT of the terminal is not activated.
Switch the UT of the terminal on.
The terminal is not connected to the ISOBUS.
Connect the ISOBUS terminal to the ISOBUS.
Incorrect configuration of the UT of the terminal.
The UT of the terminal must have UT number 1.
The in-cab plug on the fixed cable is open.
Plug in the terminating resistor included in the scope of
delivery.
The operating elements of
the CCI A3 are not dis-
played on the terminal .
The AUX assignment can-
not be performed.
The terminal and/or the implement are not certified accord-
ing to AUX-N.
→ If the implement does not support AUX-N, it cannot be
operated with the CCI A3.
→ If the terminal does not support AUX-N, the AUX assign-
ment cannot be performed.
Check in the AEF database whether the combination of
AUX control , terminal and implement you are using is
compatible.
The AUX assignment could
be performed, however
the CCI A3 does not dis-
play any pictograms of the
implement functions.
The buttons are labelled
with F1, F2, F3, etc.
This is not a mistake. The implement can be operated with
the CCI A3.
→
Not all implements display pictograms of the implement
functions on the CCI A3.
→ The buttons trigger the implement functions, that you
have assigned to them in the AUX assignment .
Use the generic pictograms of the CCI A3 (
⇒
Chap-
ter 3.9)