background image

2

© Island Pellet Stoves 2016

Lundy 5kW Operation Manual - 19.02.16

SAFE T Y

• 

It

 is forbidden for the stove to be used by children!

•  Do not operate the stove with the door open. It is a ‘Closed Door’ unit.
•  Do not place objects on top of the stove as the surface will get very hot.
•  We recommend a safety guard to be used to prevent children or animals from touching the 

stove.

•  The safety and adjustment devices must not be modified without the authorisation or indications 

of the manufacturer. Only use replacement parts recommended by the manufacturer.

•  Do not pull, disconnect, or twist the electrical cables leaving the stove, even if disconnected 

from the electrical power supply mains.

•  Do not close or reduce the dimensions of the airing vents in the place of installation.
•  External  Ventilation  requirements  in  accordance  with  Building  Regulations,  Approved 

Document J.

•  The stove door must always be closed during normal functioning of the product.
•  The appliance, especially the external surfaces, will be hot to touch when in operation and that 

due care will need to be taken.

•  Avoid direct contact with parts of the appliance that tend to heat up during operation.
•  Check  for  the  presence  of  any  obstructions  before  switching  the  appliance  on  following  a 

prolonged standstill period. 

•  It is recommended to position the power supply cable in a way that it does not come into contact 

with hot parts of the appliance. The power supply plug must be accessible after installation.

•  This  appliance  must  not  be  used  to  burn  coal,  waste  or  fuel  not  recommended  by  the 

manufacturer.

•  Do not use any inflammable liquids for ignition.
•  During the filling phase do not allow the bag of pellets to come into contact with the stove top.
•  The stove has been designed to function in normal climatic conditions. In particularly adverse 

conditions (strong winds, freezing) safety systems may intervene that switch the stove off. If 

this occurs, contact the technical after-sales service and always disable the safety system.

•  Flues need to be swept clean annually. If the flue should catch fire, request help from the fire 

service and switch off the device. 

•  If the stove should block or stop feeding when running, indicated by the signal on the display 

and it is not due to lack of routine maintenance, contact the technical after-sales centre. 

•  The user will need to adhere to any necessary safety clearances from combustible materials 

and guidance on protecting against the risk of fire in and outside the radiation area;  

•  Properly installed and operated this appliance will not emit fumes. Occasional fumes from de-

ashing and re-fuelling may occur. Persistent fume emission is potentially dangerous and must 

not be tolerated. If fume emission does persist, then the following immediate actions should 

be taken: 

- Open doors and windows to ventilate the room.
- Let the fire out and safely dispose of the fuel from the appliance.
- Check for flue or chimney blockage, and clean if required.
- Do not attempt to re-light the fire until cause of fume has been identified, if

  necessary seek professional advice.

Summary of Contents for LUNDY5















Reviews: