Linear units with spindle drive LES 4, 5, 6
48 / 52
April 2019
12
Installation explanation according to MD 2006/42/EC
Installation explanation according to EC Machinery Directive (MD) 2006/42/EC, Appendix II B
The manufacturer
isel Germany AG
Bürgermeister-Ebert-Straße 40
D-36124 Eichenzell, Germany
hereby declares that the product (
incomplete machine
)
Product description:
Linear unit LES4
Item number: 2340xx xxxx
Linear unit LES4
Item number: 2341xx xxxx
Linear unit LES5
Item number: 2343xx xxxx
Linear unit LES5
Item number: 2344xx xxxx
Linear unit LES6
Item number: 2346xx xxxx
Linear unit LES6
Item number: 2347xx xxxx
complies with the fundamental
health and safety requirements
of EC Machinery Directive
2006/42/EC Appendix I.
The following harmonised standards were applied:
EN ISO 12100:2010
Safety of Machinery - Safety of machinery -- General principles for design --
Risk assessment and risk reduction
EN 349:1993+A1:2008
Safety of Machinery -
Minimum distances to avoid the Bruising of body parts
EN 60204-1:2006
Safety of machinery. Electrical equipment of machines
- Part 1: General requirements
The following additional EC Directives relevant to this product were applied:
Low Voltage Directive 2014/35/EC
The
technical documentation
for this incomplete machine was produced according to Appendix VII
Part B. The manufacturer undertakes to pass on these technical documents to national authorities in
electronic form on request.
Member of staff responsible
for producing the technical documents or assembly instruc-
tions/installation explanation is:
Christian Bley (
CE coordinator, isel Germany AG)
The product (incomplete machine) is intended for installation into a machine or combining with other
incomplete machines to form a machine as defined in MD 2006/42/EC, Article 1, Section (1) a.
This incomplete machine (product) must not be commissioned until the machine in which this
product is installed or of which it forms a component meets the provisions of all the relevant
directives (especially MD 2006/42/EC) and this (complete) machine carries a CE mark.
Place, date:
Dermbach, 21 April 2016
_____________________________
Werner Kister, Member of the Management Board
