Isel ICP 2015, Operating And Maintaining Instruction

Page: 9 / 28

™
isel-
ʜ“«>VÌʵՈ«“i˜ÌÊÊ*
ÓÊÝ
During transportation, please pay attention to the supply and connection cables (remove if
needed) so that they are not damaged. Use only suitable lifting devices.
LœÛiÊ>]ʎii«ÊÌ iÊÌÀˆ>˜}Տ>ÀÊÜÀi˜V Ê>Ü>ÞÃÊ œÕÌÈ`iʜvÊÌ iʓ>V ˆ˜iÊ`ÕÀˆ˜}
ÌÀ>˜Ã«œÀÌ>̈œ˜°
The V>“«ˆ˜}ÊÃiÌ is made up by a hand
lever clamping assembly and two stop
bars with mounting hardware for the T-slot
plate.
Ü>ÞÃÊi˜ÃÕÀiÊÌ >ÌÊÌ iÊܜÀŽ«ˆiViÃÊ>ÀiÊ«Àœ«iÀÞÊÃiVÕÀi`°
œ˜˜iV̈œ˜Ã to the controller of the machine (type model 1):
➀
Z-axis (Amphenol connector)
➁
X-axis (Amphenol connector)
➂
Y-axis (Amphenol connector)
➃
A-axis (axis of rotation )(Amphenol connector) The pin allocation of
➄
START and STOP push-button (9-pin connector) the connectors
➀
-
➆
➅
hood switch (9-pin Sub D connector) is located in the
➆
POWER / emergency push-button (15-pin connector) technical data
➇
grounding point
➈
tooling machine
For the >VViÃÜÀˆiÃ] different parts are already pre-installed or prepared for mounting.
For this purpose, also read the information in the appendix.
You can connect the cable of a tooling machine to the coupler
terminal block in the branch box at the side of the Z-axis.