Isel ICP 2015, Operating And Maintaining Instruction

Page: 20 / 28

Óä
isel
‡ ʜ“«>VÌʵՈ«“i˜ÌÊ*
Please refer to the following drawing for the positions of fuses (
➁
,
➃
,
➅
,
➆
,
➈
) and LED’s
(
➀
,
➂
,
➄
).
œ˜ÌÀœiÀÊ«Àˆ˜Ìi`ÊVˆÀVՈÌÊLœ>À`ÊLi ˆ˜`ÊÌ iÊÀi>À‡«>˜i
➀
Controller LED Processor supply voltage 10 V/5 V
➁
Input fuse 1,25 Amp, slow ones
➂
Controller LED 24 V I/O voltage
➃
Input fuse 1,25 Amp, slow-blow
➄
Controller LED 24 V safety circuit voltage
➅
Input fuse 1,25 Amp, slow-blow
➆
Supplementary output fuse 230 V, 1,25 Amp, slow-blow HBD
➇
Supplementary output connector 230 V
➈
Tooling machine fuse 230 V, 5 Amp, slow-blow HBD
➉
suppl. outp. 9-pin Sub-D f. con. 15 mA max.
suppl. inp. 9-pin Sub-D fem. con.
H1 jumper field
For special cases (if a switch is defective or in case of power failure etc.), you can manually
open the hood interlock using the triangular wrench.
£° Switch off the machine.
Ó° Remove the four screws of the sheet metal lid of the chassis, then remove the lid.
ΰ Insert the triangular wrench into the interlock from the back and turn it around half a turn
to the left without applying excessive force.
9œÕʓ>ÞʘœÌʜ«iÀ>ÌiÊÌ iʓ>V ˆ˜iʈ˜ÊÌ ˆÃÊÃÌ>Ìi°
The tooling machine remains de-energized.