Iseki SF310, Operator'S Manual, Page: 60 / 92

SF310,370
58
o. Loosen the lock nut,9, of the trunnion arm stopper
bolt,10, and screw in the bolt slightly to shorten the
effective length.
p. Remove the spring,11, and then lift up the neutral arm
and turn the trunnion arm toward B until it stops.
q. Then adjust the effective length of the stopper bolt until
the head comes into contact with the stopper,12.
r. Lock the reverse stopper,13, in a position where the
trunnion arm comes into contact with it when the arm
turns half the forward turn.
s. Reinstall the spring. The specified spring length,A, is 98
mm when the trunnion arm is in neutral condition. Readjust
the length if the difference is over +2/-0mm.
NOTE: If the neutral arm does not move smoothly, lubri-
cate it.
14. INDEPENDENT BRAKE PEDALS (E6 type)
Adjustment of the master brake pedal play may affect the
height of both pedal tops. If so, correct the height of the
left-hand pedal top,1, to align with the right-hand pedal
top,2, by adjusting the effective length of the stopper
bolt,3.
a. Loosen the lock nut,4, of the stopper bolt behind the
pin,5.
b. Adjust the effective length of the stopper bolt so that
the left hand pedal top aligns with the right hand pedal
top.
IMPORTANT: Never fail to tighten the lock nut of the
stopper bolt securely after adjustment.
15. WHEEL TIGHTENING BOLTS AND NUTS
Check the wheel tightening bolts and nuts for looseness.
All loose bolts should be tightened to the specified level.
Specified tightening torque:
Front wheel: 1,000~1,200 kgf•cm
Rear wheel: 900~1,100 kgf•cm
(1) Neutral arm (5) Trunnion arm
(9) Lock nut (10) Stopper bolt
(11) Spring (12) Stopper
(13) Reverse stopper
(1) Independent brake pedal (LH)
(2) Independent brake pedal (RH)
(3) Stopper bolt (4) Lock nut
(5) Pin (6) Brake rod (LH)
5
9 10 12
1
11
B
A
FIG. 91
2
1
5 3 4
6
FIG. 92