Troubleshooting
The following troubleshooting symptoms and solutions
are provided to help resolve basic problems that may arise
during setup and initial operation of the CMR-KIT remote
control system. If the problem cannot be resolved using this
information, contact a Irritrol Customer Service representative
at 1-800-634-TURF (8873) for assistance. Normal office hours
are Monday–Friday, 7:30 a.m.– 4:00 p.m., PST.
The controller station does not turn on.
Solution
❖
Verify the handheld transmitter and receiver are set to
the same address code. Confirm the receiver Activity
monitor momentarily flashes Red when a command
is sent from the transmitter. If the Activity monitor
continues to flash only Green, communication is not
established. Refer to pages 13–15 for address code
setup information.
The controller station number is higher than can
be selected on the transmitter.
Solution
❖
The transmitter station number range is adjusted too
low for your controller application. Refer to page 15 the
adjustment procedure.
The communication range is very short.
Solution 1 of 2
❖
Change the receiver location slightly. Try increasing the
installed height and/or moving the receiver slightly left
or right. Sometimes small changes can result in
substantial increases in reception range. Make sure the
receiver is not located within 3' of any large metal
objects or metal studs. Metal objects below the receiver
are ok; metal objects near or above the receiver antenna
height may decrease reception performance.
18
CMR-KIT
Troubleshooting
Irritrol CMR-KIT 10/27/06 10:55 AM Page 18
Summary of Contents for CMR-KIT
