Irritrol CMR-KIT, User Manual

Page: 10 / 24

6 – Locate the controller’s remote RJ-11 jack and insert
the modular connector. See Figure 2.
The controller illustrated in Figure 2 is shown for
reference only. Refer to the controller user’s guide for
specific installation information.
7 – Locate the controller’s 24 VAC connection terminals
and attach the receiver power wires. Connect either
wire to either terminal.
8 – Apply power to the controller. The receiver Activity
monitor should begin flashing Green. If the Activity
monitor does not illuminate, confirm the receiver is
properly installed and plug assembly is wired correctly.
Outdoor Installation
CAUTION: The receiver plug is weather resistant only
when installed in PVC conduit and the plug cover is in
place. The receiver unit is not weather resistant and
should only be installed outdoors for temporary use. Do
not allow irrigation spray to contact the receiver during
sprinkler operation.
1 – At the selected installation site, bore a
3
⁄
4
" hole through
the wall for 1 ⁄
2
" PVC pipe access.
2 – Install a length of PVC pipe through the wall, leaving
about 1" of pipe on both sides.
3 – Inside, install a 90° elbow and a 3" section of pipe.
Use a conduit clamp to secure the pipe assembly to
the wall. See Figure 3.
4 – Remove the mounting bracket from the plug assembly.
5 – Insert the receiver plug wiring through the threaded
end of a 1 ⁄
2
" thread/slip PVC fitting. Thread the receiver
plug into the PVC fitting tighten by hand.
6 – Route the wiring through the conduit. Install the
plug/fitting assembly to the pipe, orienting the plug
alignment hole pointing straight down.
7 – Connect the receiver plug wiring as described above.
8
CMR-KIT Outdoor Installation
Irritrol CMR-KIT 10/27/06 10:55 AM Page 8