Reset Receiver Address Code
When the receiver is initially powered up through the plug
assembly, its address code can be accessed and adjusted
for period of 30 seconds through the handheld transmitter
keypad. To perform this task, you must have access to the
receiver, receiver plug assembly and the modular cable
connection to controller.
1 – Unlock and remove the receiver from the
plug assembly.
2 – Remove the modular cable connection
from the controller’s remote receiver jack.
3 – Press and hold the
ON button until the
transmitter powers up.
4 – Press the
Address button to access the
address code function. The current address
code in the transmitter will be displayed.
5 – Press and hold the
Address button
until the word ADDRESS and the third
digit of the address code begin flashing,
then release.
The address code selected in the following procedure
will be entered into the transmitter and the receiver.
6 – To adjust the digit, press the
up or
down arrow button. To select another
digit, press the
left or
right arrow
button. Repeat in the same manner to
select the desired address number
7 – When the receiver address code is displayed correctly
and flashing, reinstall the receiver. The receiver
Activity monitor should begin flashing Green.
8 – Press and hold the
Address button. When the
receiver Activity monitor momentarily flashes Red
release the button.
14
CMR-KIT
Setup Options
Irritrol CMR-KIT 10/27/06 10:55 AM Page 14
Summary of Contents for CMR-KIT
