Remote Control Operations
For the best results, please note the following CMR-KIT
remote system operating characteristics:
The transmitter batteries must be fully charged prior to
operation.
Refer to battery charging procedure on page 16.
For maximum signal range, hold the transmitter vertically,
at shoulder level, facing toward the receiver when sending
a command.
Operating the transmitter in a horizontal plane
and/or contacting the antenna during transmission can
significantly reduce signal range.
The highest station number that can be selected is 24 (by
default), but is easily adjusted from 1 to 512 as preferred.
To adjust the station number range, refer to the procedure
on page 15.
Basic Station Operation
1 – Press and hold the
ON button until the
transmitter powers up.
The last station
number operated will be displayed on the
initial start up screen. The valve symbol
indicates a station number is shown.
2 – Press the
up or
down arrow button
to select a station number.
For rapid
scrolling, press and hold the button.
3 – Press the
ON button.
The receiver
Activity monitor will flash Red to indicate a
valid signal is received. The selected station
will turn on and the timer will begin counting
down from 10 minutes in one-second
increments. The water droplet indicates
watering activity and the hour glass indicates
run time remaining. Every 15 seconds, the
display will alternate to show the currently
operating station number.
The station run time is fixed at 10
minutes and cannot be adjusted.
10
CMR-KIT
Remote Control Operations
Irritrol CMR-KIT 10/27/06 10:55 AM Page 10
Summary of Contents for CMR-KIT
