3
Ref. no. 31-8939-0201-05/1805
1131 X2
Warnings
NOTE
To ensure the selection of the most suitable feeder and associated accessories, it is recommended making
weaving tests with the intended yarns.
Please dispose of obsolete or unwanted equipment responsibly, taking into consideration any local regulations regard-
ing the disposal and / or recycling of materials that are applicable
WARNING
!
• The loom must be switched off at the mains before any
work is carried out on the feeder, interface or cables.
The weft feeder ON/OFF-switch DO NOT cut off the main
power supply.
• Always turn off the main switch before connecting or
disconnecting the feeder, the interface control board,
cables or any of the circuit boards or electrical compo-
nents.
• The feeder and the interface box contain electrical com-
ponents that retain an electric current up to one minute
after switching off loom main power. DO NOT open or
disconnect feeder or interface, including cables, within
this time.
• The feeder, interface cabinet and cables must be fully
assembled before the power is switched on.
• All work on electrical components must be carried out
by a qualified electrician.
• This product is NOT intended for use in potentially
explosive atmospheres or in zones classified according
to the European directive 94/9/EC.
• Routine checks for damaged or worn parts must be
made before operating this equipment. Any part that
is worn or damaged should be properly repaired or
replaced by authorized personnel. To avoid risk of
injury DO NOT operate this equipment if any component
does not appear to be functioning correctly.
• Take necessary precautions to avoid injuries when
interacting with the product. Use suitable respiratory
and eye protection.
• Improper handling at repair, fault finding or similar
may damage the feeder/interface mechanical/electrical
components including cables and connectors. DO NOT
perform measurements on feeder electrical components
and parts.
Please contact your local IRO service station for further
information.
CAUTION
!
• Caution must be taken in the close vicinity of the feeder
as it contains moving parts that can cause injuries and,
in normal operation, starts without prior warning.
• To comply with C.E. Regulations only replacement parts
approved by IRO AB may be used.
• The feeder is an industrial product and therefore not
approved to use household environments /in residential
areas.
