11
Spool body Circumference
Ref. no. 31-8939-0201-05/1805
1131 X2
Settings
No. of Winds
Pick lengthrange (MM)
Min
Max
1
379
511
2
758
1022
3
1137
1533
4
1516
2044
5
1895
2555
6
2274
3066
7
2653
3577
8
3032
4088
9
3411
4599
10
3790
5110
The required pick length is the deciding factor when calculating the spool body circumference and the
number of windings for each pick. The table below indicates the pick length ranges that can be obtained
from different numbers of windings. To calculate the appropriate spool body circumference / number of
windings per pick, proceed as follows:
1. Determine the required pick length (drawing-in width plus waste).
2. Using the table below determine a pick length range that covers the required pick length.
3. The number of windings necessary to obtain the required pick length will be found in the left hand
column. Adjust the spool body to the required circumference as follows:
Stopper unit
positioning screws
1,0 mm
Eyelet
Move the stopper unit to its uppermost position before any adjustments are carried out.
Adjust each finger in turn, first the fixed finger then the yarn transport finger. Only loosen the screw
sufficiently to move the finger, excessive loosening gives faulty values. When adjusting the yarn transport
fingers the winding disc eyelet must be aligned with the centre of the finger being adjusted.
YARN TRANSPORT FINGER ADJUSTMENT:
1. Align the winding disc eyelet with the finger to be adjusted.
2. Loosen the screw.
3. Insert the short end of the transport finger guide between the fixed finger and
the yarn transport finger.
4. Adjust the yarn transport finger towards the fixed finger until the guide is felt.
Then thighten the screw whilst holding the guide and finger in place.
FIXED FINGER ADJUSTMENT:
1. Loosen the screw.
2. Adjust the finger using the circumference scale on the front plate as a reference.
3. Re-tighten the screw.
