6.01 Hardware Installation (Continued...)
1. Once you
ʼ
ve established a suitable installation position, offer the camera in to place and mark of the six fixing holes. Alternatively, use
the drilling template supplied to mark of the fixing positions and cable entry hole.
2. Use a suitably sized drill to create pilot holes for the 6 x 1/4”x3/4” fixing screws.
3. Use a 35mm hole saw to create the cable entry hole
4. Apply a thin bead of water resistant marine silicone around the rim of the camera base to prevent water ingress through the screw
holes and cable entry point.
5. Pass your cable through the cable entry hole and connect to the base of the camera, ensuring the waterproof back shell is fully
tightened and not cross threaded.
6. Position the camera as desired and fix into place with the 6 x 1/4”x3/4” fixing screws. Loosely tighten each of the six screws so the
camera is in the correct position and then fully tighten each screw until secure. Make sure you do not over-tighten. If whilst fixing the
cameras it becomes difficult to tighten a screw, or the GRP shows signs of stress, remove the screw and carefully open out the pilot
hole slightly to relief the stress.
V3.00 Iss 05-06 18 - 11
