Installation Instructions for Thinkware VHL3Z-19G490-C & VHL3Z-19G490-D
Dash Cam
1
Locate the OBD II connector inside the vehicle and remove it from the mounting surface.
For this it may be necessary to remove the two 8mm nuts that fix it to the bottom of the
board (Fig a) or press the two clips, with the tool of the lining of the plastic board, which
secure it behind the plastic cover protective (Fig b)
2
Connect the male end of the HWK-TW01-HAR Plug-n-Play to the OBD II factory
connector of the vehicle (Fig A)
3
Secure the OBD II connector with the harness using one of the straps cut the excess of
the strap (Fig B)
4
In the case of the bolt and nut assembly: place the left flange of the connector on the
factory left bolt, and replace and adjust the nut removed in step 1. Secure the right
flange of the connector under the board using the included self-tapping screw (FIG C).
In the case of clip mounting: place the body of the harness in the opening of the board
and secure the connector to the board using the included self-tapping screws (Fig D).
