Iris Innovations IRISx460, Quick Start Manual

Page: 4 / 20

Iris Innovations
Warnings & Important Product
Information
WARNING: Installation and Operation
This product must be installed and operated in accordance with
these instructions. Failure to do so may result in poor product
performance, damage to the product or vessel and or personal
injury. Installation should only be carried out be qualified
personnel or by persons competent in electrical systems.
WARNING: Power Supply and Grounding
Ensure the boats power supply is switched off during installation.
Ensure suitably rated circuit breakers / fuses are used in the
installation of the product in accordance with the electrical
values shown in the technical specifications of the product.
Never switch on power until the power connections are correctly
terminated in accordance with the information provided in this
document. Do not connect or disconnect the product with the
power supply switched on. Never disconnect the DC ground with
the power supply on.
WARNING: Wiring terminations
Where the products video, power and data terminations are
extended, ensure that suitable connectors are used and that the
point of termination for each cable is adequately protected
against moisture ingress. Ensure correct polarity is strictly
observed. Do not cut or remove cable connectors without prior
permission from Iris Innovations Limited.
WARNING: Do Not Open the Unit
There are no user serviceable parts within the product so there s
no need to open the device. The product has been certified to
IP66 standards, however, submersion or the product or
exposure to high pressure washing will invalidate the warranty.
WARNING: Disclaimer
This product is intended to be used only as an aid to navigation
and must never be used as an alternative to correct navigational
practices and judgements made on the basis of approved
navigation methods. It is the users responsibility to observe
correct and proper navigational skill when using this product.
Only officially approved charts and notices to mariners contain
the current information required for safe navigation.
Operating the camera or viewing the video input whilst the
vessel is moving could cause a distraction and result in
accidental collision resulting in property damage, injury or death.
Iris Innovations cannot be held liable for any incidental, special,
indirect or consequential damages whether resulting from the
use, misuse or inability to use this product.
CAUTION: Switch Camera Off When Not in Use.
To prolong the operation life of the the cameras sensor we
strongly advise that power to the camera is routed via a
dedicated switch.
CAUTION: Service and Maintenance
This product contains no user serviceable parts. Please refer all
maintenance and repair issues to your authorised Iris
Innovations dealer. Any unauthorised work to the product may
affect the warranty.
CAUTION: Care and Cleaning
This product is a sensitive piece of electronic, imaging
equipment and must be handled and treated accordingly. Do not
drop or shake the unit during installation. Avoid exposure of the
imager to direct sunlight where possible as this may degrade the
cameras performance over time.
When cleaning the device, ensure power is switched off. Clean
the camera housing with a soft cloth. Moisten the cloth and use
a mild detergent if required. The lens window has a protective
coating which may suffer damage as a result of improper
cleaning. To clean the lens window use a soft cotton cloth.
Moisten with clean water if necessary. For further advise on
cleaning the lens window, contact Iris Innovations.
I NFORMATION: Product Disposal and Recycling
Dispose of this product in accordance with the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE)
Directive requires the recycling of waste electronic and electrical
equipment. Iris Innovations supports the WEEE policy and
politely request you observe correct disposal methods. For
further information on how to correctly dispose of this product
please contact Iris Innovations.
Please recycle unwanted packaging and documentation. The
cardboard carton, all paper manuals and documents and the
protective plastic bag in which the camera is shipped are widely
recyclable. Please check with your local recycling plant for
confirmation.
EMC Guidelines
This camera is designed to be used as a visual aid and is not
part of the vessels navigational system - even if used in
conjunction with other on board equipment or third party
systems - and is compliant with the EMC directive 2014/30/EC.
The original Declaration of Conformity (DoC) is available from
our website
The camera should not be installed on the ships helm or in close
proximity to radio receiver equipment. We recommend the
camera is installed no closer than 1m from any equipment
transmitting or cables carrying radio signals - particularly VHF
radios and associated equipment.
The camera should be powered from a clean 12VDC supply. If
when powered via a Power over Ethernet (PoE) connection any
interference occurs on either the camera or nearby equipment,
the effected equipment should be separated by a greater
distance.
Water Ingress: Disclaimer
This product has been tested and complies with the
requirements of the standard EN60529 to level IPx6, however,
water intrusion and subsequent equipment failure may occur is
subject to commercial high pressure washing or sustained
exposure to water spray. This product is not designed to be
submerged. Any damage caused as a result of these
circumstances are not covered by the product warranty.
NOTE:
Due to manufacturing techniques there may be minor variations
in the form of the stainless steel cowling. This is expected and
does not detract from the performance and overall aesthetic of
the product.
IRISx460 User Guide v2.3 April 2021
4