QPSK/IP DEMODULATOR
Protocol:
select the protocol for multicast: UDP or RTP.
TS Pkts Per UDP:
set the number of the TS packages encapsulated in one UDP package. The valid
range goes from 1 to 7.
Time To Live:
set the number of the routers over which the TS over IP can be transmitted. The valid
range goes from 1 to 5.
Type of Service:
select the type of service. There are: Normal, Min Monetary Cost, Max Reliability,
Max Throughput or Min Delay optional.
Source:
select the source of the transport stream over IP streaming output. There are 4 type of source
optional:
ASI Input
CI De-encrypted
TUNER
Mux TS
(note the Mux TS is showed only when the Mux/Filter function block is enabled and turned on.
The Mux TS indicates not only the after-multiplexed TS when Mux is enabled, but also the after-filtered
TS when the filter is enabled, refer to section 7.3.6 and section 7.4.6 for how to set the Mux / Filter
function block)
After the operation, the selected transport stream will be delivered to the TS / IP function block for
further operation.
Mode:
select the mode of IP stream, you can select DVB or IPTV.
DVB mode:
the transport stream which comes from the
‘source’ selected in previous step will be
packed into IP Stream directly. Therefore the IP stream carries all programs and be delivered to the
specified Multicast or Unicast IP address.
IPTV mode:
the transport stream which comes from the
‘source’ selected in previous step will be de-
Muxed to several single programs, and each program is packed into one IP stream. Therefore each IP
stream carries only one program and be delivered to the specified Multicast or Unicast IP address. You
can configure maximum 6 IPTV channels.
Multicast Setup:
use <ENTER>-key to enter sub-menu. The sub-menu is different according to
different
‘mode’ selected in previous step.
DVB mode
Multicast IP:
Enter the IP address of the IP stream for the transport stream over IP output. You can
configure the IP stream output mode in Multicast or Unicast.
Multicast could be established by setting Multicast IP address in the range of 239.255.255.255 to
224.0.0.0.
Unicast could be established with the same settings of Multicast, the only differences are the Multicast
IP address, and should NOT be in the range of 224.0.0.0 to 239.255.255.255, which is for Multicast.
Although the display is 'Multicast IP' on the first row, the stream itself is Unicast. The IP address of
receiver device (maybe PC with VLC) needed to be set to as the unicast address on This equipment
-
x, please don't use DHCP to get a dynamic IP address for receiver device.
Multicast UDP Port:
Enter the UDP port number of the TS over IP stream output.
IPTV mode
Max Channels (<=6):
you can configure the number of IPTV channel. The valid range goes from 0 to
6.
After the configuration, you can use
< > < >-keys
to roll up and down between the channels.
Each channel could be configured independently.
Channel x:
‘x’ means the channel number. Press
<ENTER>-key
to go down to the sub-menu. There
are 4 sub-menus:
x-Multicast IP:
Enter the IP address of the IP stream for the transport stream over IP output.
You can also configure the IP stream output mode in Multicast or Unicast by setting Multicast IP
address.
16
