QPSK/IP DEMODULATOR
Multicast IP
Addr
Enter the IP address for streaming IP input of the unit
Multicast UDP
Port
Enter the UDP port number of the TS over IP stream
Protocol
select the protocol for multicast: UDP or RTP.
Output
Smoothing
set the quality of TS which comes from the TS/IP input
Auto:
the bit rate is variable.
Disable:
the unit let the TS pass by.
Fixed Rate:
the bit rate is fixed.
TS Bit Rate
Fixed Rate:
the bit rate is fixed.
Outputs
Under Outputs Menu, you can monitor and configure the parameters of the CI, AV decoder, ASI
out, ASI2/SDI out, Mux/Filter (A), and TS over IP output (B).
(A) The Mux/Filter menu is showed only if the functional block is enabled. Refer to section 7.4.6.
(B) The menu is showed only if the IP streaming in/out board is installed and the TS/IP streaming
board is set to
“IP Out”. Refer to section 7.4.6.
Outputs
Status
CI
Decoder
ASI
ASI2/SDI
Mux/Filter
Ethernet
(option)
7.3.1 Ethernet
Figure 7.3 Outputs Menu Structure
There are 3 displays on the LCD for monitoring the status of the decoder, the common
interface.
- Decoder:
OK or Alarms indicates the status of the decoder. You can use
t
he <ENTER>-
key to check detailed information in the submenu of the
d
ecoder
.
- CI:
You can check the information of the CAM Modules in Slot1 and Slot2.
7.3.2 CI
There are two PCMCIA slots for inserting CAM for de-encrypting program from the input
signal.
Before setting CI, ensure the signal from ASI input is locked or the Tuner locks on the correct
Transponder (this depends on in which signal the encrypted program carried). The
‘Tuner
Lock’ LED will 'on' in green.
There are 2 submenus:
‘CI Source’ and ‘Setup’ which allow you to set or select the parameters
of the CI.
12
