www.iReliev.com
13
STEP 4 - Remove Electrode Pads from Plastic Film
To extend the life of the electrode pad(s), place the pad(s) back onto the plastic fi lm after use.
Note:
The electrode pad(s) are disposable and use an adhesive gel that will dry out and
deteriorate after prolonged use and/or storage. The pad(s) can be used approximately 20-30 times
based on 30-minute intervals. The electrode pad(s) should be replaced when they lose their
adhesiveness and/or when you sense a change in the stimulation “tingling sensation”.
STEP 5 - Place Electrode Pads on Skin
Electrode pad placement location recommendations can be found on pages 16-17.
STEP 6 - Turning On & Off the Device
To Power On: Press and hold the “ON/+” button for 3 seconds.
To Power Off: Press and hold the “OFF/-” button for 3 seconds.
Note:
If any of the treatment settings are fl ashing, the device will not turn off. To prevent unpleasant
electric shocks, never remove the electrode pad while the device is still turned on. In case of
an emergency, you may unplug the respective lead wire directly from the device.
Note:
The last program you used will be stored and appear on the display when you turn on
the device.
STEP 7 - Select TENS or EMS
Press the “MODE” button (center button) and the Therapy Mode in the upper right corner of
LCD screen will begin fl ashing. To select TENS or EMS, press the “ON/+” button for TENS or
the “OFF/-” button for EMS, then press “MODE”.
Summary of Contents for Plus Pain Relief & Recovery ET-8080
Page 33: ...www iReliev com 33...
Page 34: ...www iReliev com 34...
Page 35: ...www iReliev com 35...
