Model 2100,2080,2000 Ver.14.0
12
(d) Family Budget and Silver Series Configurations
VL401 control panel
For every time the Spa is powered, it will go into
Priming mode.
Display ―
Pr
‖ The Priming mode will last for
up 4 minutes. Then the spa will begin to heat and maintain the water temperature in
Standard mode.
IMPORTANT check for air lock in the circulation system
Temp Control (26°C - 40°C)
The last measured water temperature is constantly displayed.
The water temperature displayed is current only when the pump has been running for at least 2 minutes. to
display the set temperature, press ―Warm‖ or ―Cool‖ once.
To change the set temperature, press a temperature button again before the display stops flashing. Each
press of ―Warm‖ or ―Cool‖ will adjust the set temperature. After three seconds, the display will stop
flashing and begin to display the current spa temperature
.
Work Mode
The spa can work at standard, economy, sleep modes. Work mode is changed by pressing ―Cool or
Warm‖ button then press the ―Light‖ button to adjust it.
Standard Mode
is programmed to maintain the desired temperature .Note that the last measured spa
temperature displayed is current only when the pump has been running for at least 2 minutes, ―St‖
will be displayed momentarily when you switch into Standard Mode.
Economy Mode
heats the spa to the set temperature only during filter cycles, ―EC‖ will display solid
when the temperature is not current, and will alternate with temperature when temperature is
current.
Sleep Mode
heats the spa to within 20°F /10°C of the set temperature only during filter cycles. ―SL‖
will display solidly when temperature is not current, and will alternate with temperature when
temperature is current.
Jets
To start pump (two speed) press ―Jets‖ one time, the pump1 will work at low speed, then press
OR
OR
