I P Wi r e l e s s B r o a d b a n d M o d e m U s e r G u i d e
1 3
Conn ect th e AC Pow er Adap ter
1. Plug the pin end of the power cable into the DC power jack located on the
side of the IPWireless Broadband Modem as shown in Figure 3 below.
Figure 3
Note
:
Before connecting your IPWireless Broadband Modem to a power source
in the next step, you may want to consider using a power surge protector. A
surge protector is designed to protect electronic devices from electrical surges
and lightning strikes that may damage your computer or modem. If you don’t
have a surge protector, contact your local computer or electronics retailer for
further details.
2. Plug the AC power adapter into a 120V or 240V AC power outlet.
3. To disconnect the unit from mains power, remove the mains adapter from
the wall socket.
Find th e Best Radio Si gnal
1. Place the IPWireless Broadband Modem near your computer and press the
power button for one second to turn it on.
2. Your IPWireless Broadband Modem will perform a short self-test that will
last for approximately five seconds.
The IPWireless Broadband Modem will
search for the best radio signal and then display the signal strength on the
inner center of the modem display.
3. When the self-test is complete, the power and battery indicators on the
display will illumi nate. If these indicators flash on and off, there may be a
problem with the IPWireless Broadband Modem. Call IPWireless Technical
Support.
Note
: The display will dim after two minutes to conserve battery life
-- this is normal. A momentary press of the power button will restore the
brightness of the display.
