14
iPor t ver. FS
Ins tr uction Manual
the Advanced Connection Box location to the Audio Sender Wallplate. (For FS-5 systems run a
second length of Cat5 from the Advanced Connection Box to the Video Sender Wallplate.) Install
RJ-45 connectors on both ends of the Cat5 cables as explained in the
Cat5/RJ-45 Cable Wiring
sidebar on page 11.
11. As shown in
Figure 10
, plug the audio Cat5 cable into the
To Audio Wallplate
jack on the Advanced
Connection Box and the RJ-45 jack on the Audio Sender Wallplate.
11a. For FS-5 systems, plug the video Cat5 cable into the
To Video Wallplate
jack on the Advanced
Connection Box and the RJ-45 jack on the Video Sender Wallplate, as shown in
Figure 10
.
12. If the IR and/or RS-232 control system is local to the iPort On-Desk System, connect them direct-
ly to the their respective jacks on the Advanced Connection Box, as shown in Figure 10.
Note: Do not connect the control systems to the Advanced Connection Box if you’ve already
connected them to the Balanced Audio Receiver Wallplate, as shown in Figure 8.
13. For FS-5 systems, connect the Video Receiver Wallplate to the video monitor, as shown in
Figure 9
.
Note: You can use both the composite and S-Video connections simultaneously.
14. After confirming that all of the connections have been made correctly, plug the in15V DC
power supply into the
Power
connector on the Advanced Connection Box and into a wall outlet.
iPort Video
Sender Wallplate
iPort Balanced Video
Receiver Wallplate
To
Advanced
Connection
Box
Cat5 Cable
w/RJ-45 Connector
Cat5 Cable
run through wall,
up to 250 feet
iPort
Room
Video
Equipment
Room
To
Video
Monitor
Figure 9: iPort FS-5 Video Wallplate Connections
