6
CM-IW2000 Instruction Manual
Removal
1. Ensure that the CM2000 bezel is not bonded with the wall paint.
If it has, gently place a plastic putty knife under the frame on
all sides to ensure the frame doesn’t peel the wall paint while
being removed.
2. Attach the iPort suction cup removal tool (figure 10) to the
UPPER left or right corner of the iPad touch screen.
3. Carefully pull the iPad away from the wall. The iPad and
mounting assembly will detach from the wall. Disconnect the
CAT5 cable.
4. Detach the safety lanyard from the back of the iPad mounting
assembly.
5. Place the iPad mounting assembly facedown on a clean,
smooth surface and remove the remaining machine screws.
6. Carefully separate the iPad from the mounting assembly.
Reserve the machine screws in a safe location. The screws are
needed for re-installation.
Operation
Once installed, the iPad is now fully functional. The iPort Control
Mount features a button to control the Power functionality. To
activate the Power function, press the button as noted in figure 11.
The operation of the iPad touch screen to choose applications,
music, email or internet remains the same.
Note:
For questions regarding the touchscreen functions of
your iPad, please visit: www.apple.com
Figure 11: Power Button
Figure 10: Suction Cup Removal Tool
Painting the bezel
iPort bezels are shipped from the factory with a standard
finish. The instructions below can be used as guidelines to
achieve a custom finish.
A light coat of paint to match the surrounding wall is recom-
mended. A light coat will allow the bezel to maintain all
proper tolerances and ensure precision fit. Do not roll or
brush paint onto the bezel.
1. Apply a light coat of XIM Primer/Bonder (or similar) to the
bezel. Carefully follow the directions on the can. NOTE: Match
the primer type to the specified paint.
2. As many of the bezels are used on a daily basis, it is
recommended to use a lacquer, oil or polyurethane based
paint which will provide greater durability. If a water based
paint is used, it is recommended to add a clear coat to protect
the finish and improve durability, sand as necessary to adjust
gloss level.
3. Thin the paint to the proper ratio for the application method
and paint manufacturers recommendations and standard
industry practices. Strain the paint through a standard mesh
strainer to remove any lumps.
4. Using a small touch-up gun or cap spray gun, with a #3 tip for
painting, set the nozzle with a medium to wide fan, and set the
pressure regulator to 60 psi.
5. Lightly spray the front of the bezel in three quick strokes, from
approximately 10 inches away.
6. Paint at a slight angle (approximately 45 degrees) to ensure
that the paint covers the sidewalls of the bezel. Only a very
light coat of paint is needed on the surface.
7. Let the paint set for one minute, turn the bezel 90° and repeat
the painting process for all sides.
Note:
some trial and error is involved to determine the color
Formula and Paint aPPlication. a dust Free environment
is critical For oPtimum Painting
