CM-IW2000 Instruction Manual
4
5.
Prior to placing the mounting frame into the wall, pull a sufficient
length of the Cat5 cable and its attached RJ-45 connector
through the opening in the side of the mounting frame, as shown
in figure 4.
6.
Insert the Control Mount mounting frame into the opening in
the wall.
7. Hand-tighten the four Roto-Lock screws on the Control Mount’s
mounting frame as shown in Figure 5. The Roto-Lock clamps
will automatically rotate into position behind the wall and begin
clamping the mount.
• When you notice resistance on the four screws, the Control
Mount has been clamped successfully.
IMPorTanT: nEVEr over-tighten the roto-Lock screws.
8. Mount iPad to the bezel by placing iPad into nesting area on
rear of bezel and attach metal retainer with ten (10) machine
screws and washers as shown in figure 6 with the #1 Phillips
screwdriver.
Figure 4: Mounting Frame
Figure 5: Roto-Lock Screw Locations
Figure 6: Mounting iPad to bezel
