CM-IW2000 Instruction Manual
5
9. Attach safety lanyard on top center screw of retainer assembly
as shown in figure 7.
10. Install pre-assembled circuit board assembly into the iPad dock
connector on end of iPad. Metal circuit board bracket will slide
under thumb screws on the retainer. Tighten thumb screws to
secure circuit board assembly to retainer.
11. Remove thumbscrew from the interior of metal frame, install
though eyelet at the end of cable lanyard , and fasten lanyard to
central hole at top of metal frame.
12. Connect the Cat5 cable from the wall to the iPad connector
board as noted in figure 8.
Final Adjustment
1. Mounting frame is supplied with a preset height setting. The
preset adjustment will likely result with a space between the
bezel and the wall surface. To adjust the height setting, turn
screws clockwise, one turn at a time, until bezel fits snugly
against the wall as shown in figure 9.
2. Insert assembly into frame and adjust until desired results are
accomplished.
3
.
Plug the included DC power supply into the Power connector
on the wall plate and into a wall outlet, as shown in Figure 3.
Figure 7: Attaching Safety Lanyard.
Figure 8: Attaching Cat5/RJ45 cable.
Figure 9: Height Adjustment Screws
