CM-IW2000 V2 Instruction Manual
5
9. Attach safety lanyard on top center screw of retainer assembly
as shown in figure 7 (on the following page).
10. Install the charging circuit board assembly components onto
the Control Mount retainer:
1
Begin installation of the Charging Circuit Board Assembly
after installing the Fit Kit (provided with CM-IW2000
V2 for use with iPad 2 or later), and after installing iPad
between the retainer and bezel. Place the iPad assembly
“face down” to reveal the retainer (silver substrate).
2
Place the Metal Bracket (C) onto the retainer as
shown. Crimp Apple Connector Cable (Lightning or
30 Pin) to (C) using the bracket provided on (C).
Note: Apple Connector Cable not included. Use the
cable provided with iPad.
C
3
Screw on the Stand Offs (D) as shown.
D
D
4
Place the Charging Circuit Board (A) onto the Stand
Offs (D).
A
D
D
5
Screw the Thumb Nuts (E) to secure the Charging
Circuit Board (A).
E
E
A
6
Use the Wire Tie (B) to manage the Apple Connector
Cable. Plug the USB connector into the USB port on
the Charging Circuit Board (A).
Connect power wire to the Charging Circuit Board via
the provided Phoenix Connector.
B
A
7
A
Phoenix
Connector
–
Contents:
A. Charging Circuit Board
B. Wire Tie
C. Metal Bracket
D. Stand Offs
E. Thumb Nuts
A.
B.
C.
D.
E.
–
USB Port
–
Phoenix
Connector
