6
CM-IW2000 V2 Instruction Manual
Removal
1. Ensure that the Control Mount bezel is not bonded with the wall
paint. If it has, gently place a plastic putty knife under the frame
on all sides to ensure the frame doesn’t peel the wall paint
while being removed.
2. Attach the iPort suction cup removal tool (figure 10) to the
UPPER left or right corner of the iPad touch screen.
3. Carefully pull the iPad away from the wall. The iPad and
mounting assembly will detach from the wall. Disconnect the
Power Wire.
4. Detach the safety lanyard from the back of the iPad mounting
assembly.
5. Place the iPad mounting assembly facedown on a clean,
smooth surface and remove the remaining machine screws.
6. Carefully separate the iPad from the mounting assembly.
Reserve the machine screws in a safe location. The screws are
needed for re-installation.
Figure 11: Power Button
Figure 10: Suction Cup Removal Tool
Painting the bezel
iPort bezels are shipped from the factory with a standard
finish. The instructions below can be used as guidelines to
achieve a custom finish.
A light coat of paint to match the surrounding wall is
recommended. A light coat will allow the bezel to maintain
all proper tolerances and ensure precision fit. Do not roll or
brush paint onto the bezel.
1. Apply a light coat of XIM Primer/Bonder (or similar) to the
bezel. Carefully follow the directions on the can. NOTE: Match
the primer type to the specified paint.
2. As many of the bezels are used on a daily basis, it is
recommended to use a lacquer, oil or polyurethane based
paint which will provide greater durability. If a water based
paint is used, it is recommended to add a clear coat to protect
the finish and improve durability, sand as necessary to adjust
gloss level.
3. Thin the paint to the proper ratio for the application method
and paint manufacturers recommendations and standard
industry practices. Strain the paint through a standard mesh
strainer to remove any lumps.
11. Remove thumbscrew from the interior of metal frame, install
though eyelet at the end of cable lanyard , and fasten lanyard to
central hole at top of metal frame.
Final Adjustment
1. Mounting frame is supplied with a preset height setting. The
preset adjustment will likely result with a space between the
bezel and the wall surface. To adjust the height setting, turn
screws clockwise, one turn at a time, until bezel fits snugly
against the wall as shown in figure 9.
2. Insert assembly into frame and adjust until desired results are
accomplished.
3
.
Plug the included DC power supply into the Power connector
on the wall plate and into a wall outlet, as shown in Figure 3.
Figure 9: Height Adjustment Screws
Operation
Once installed, the iPad is now fully functional. The iPort Control
Mount features a button to control the Power functionality. To
activate the Power function, press the button as noted in figure 11.
The operation of the iPad touch screen to choose applications,
music, email or internet remains the same.
Note:
For questions regarding the touchscreen functions of
your iPad, please visit: www.apple.com
