tESt
Press Enter/Set button for 5sec
test-function (no Timeout)
With the Test-function you can check the adjusted parameters
without influence for the system.
The display starts with indicating the current temperature.
Due to the arrow keys the displayed value can be increased or
decreased. All parameters react as if the real temperature would
increase or decrease.
Leave the Test Mode with ESC.
The display range of the test mode is -40 … +300°C
END
End of enhanced functions.
Press the Enter/Set button twice to get into the RUN-mode
again.
The units come with an optical interface that allows all parameters to be set and ad-
justed by a PC or notebook.
The suitable interface cable and Windows-Software can be ordered with the article
number
AD000011
.
With the Software you are able to adjust all functions described above.
NOTE:
Use a shielded cable socket (e.g.
VK205321
), in order to avoid interfer-
ences.
mounting and electrical connection
For wall mounting you can order a mounting clip with the article-no.
AY000060
.
After mounting the sensor mechanically, the control panel can be rotated by 350° to
align it for the machine operator.
The unit must be connected by a suitably qualified electrician. The national and in-
ternational regulations for the installation of electrical equipment must be observed.
Voltage supply to EN50178.
The device shall be supplied from an isolating source and protected by an overcur-
rent device. Disconnect power before connecting the unit as follows:
bn= brown, wh=white, bk=black, bl=blue
terminal marking of the cable socket in clamps
MANUAL • Subject to alteration! Version:
June 2017
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
│
[email protected] • www.ipf-electronic.com
15
