PtCo
configuration for PT100 sensors:
2-4.L connection of 2- or 4-wire sensors
3.L connection of 3-wire sensors
This configuration is only programmable directly at the YT35.
0u 1
Configuration of output1:
Four switching functions are possible:
SP.HY
switch-point / hysteresis
SP.rP
switch-point / release position
FE.HY
window function / hysteresis
FE. rP
window function
/ release position
oFF.1
output 1 „off“
noc 1
noc 1
is active if in
Ou 1
a switching function is set.
Switching function of switching output S1:
no.1
(normally open)
nc.1
(normally closed)
ds 1
ds 1
is active if in
Ou 1
a switching function is set.
on-delay timer function S1
dr 1
dr 1
is active if in
Ou 1
a switching function is set.
off-delay timer function S1
Ou 2
ASP
ASP
is active if in
Ou 2
an analog signal was set.
Analog starting point:
The temperature value (low temperature) where the analog out-
put starts.
AEP
AEP
is active if in
Ou 2
an analog signal was set.
Analog end point:
The temperature value (higher temperature), where the analog
signal ends.
Note:
The minimum range between starting point and end point
is 20% of the measuring range for the DW35 type; and 50% of
the measuring range for the DW36 type.
Configuration Output 2:
4 switching functions, the error signal or 4 analog functions:
SP.HY switch-point / hysteresis
SP.rP switch-point / release position
FE.HY window function / hysteresis
FE. rP window function / release position
Err. 2 error signal
4-20 analog signal 4-20mA
0-20 analog signal 0-20mA
20-4 analog signal 20-4mA
20-0 analog signal 20-4mA
0u10 analog signal 0-10V
0u5
analog signal 0-5V
10u0 analog signal 10-0V
5u0
analog signal 5-0V
oFF.2 output 2 „off“
MANUAL • Subject to alteration! Version:
June 2017
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
│
[email protected] • www.ipf-electronic.com
13
