IPC CT46, Operator'S Manual, Page: 33 / 34

EN
The battery discharg-
es too fast during use,
even though it has been
charged correctly and
when tested with a hy-
drometer at the end of
recharging, it turned out
to be uniformly charged
(battery powered versions
only)
the battery is new and does not deliver 100% of
its expected capacity the battery must be "run-in" by performing 20-30
charges and discharges to obtain maximum per-
formance
the machine is being used at maximum capac-
ity for continuous periods and the working time
is not sufficient
if possible, use batteries with a higher capacity
or replace the batteries with others charged pre-
viously
the electrolyte has evaporated and does not
cover the plates completely top up all elements with distilled water until the
plates are covered then recharge the battery
ERROR CODE DISPLAYED
Brush button LED (fig. C, ref. 4), 2 quick flashes / pause / 2 quick flashes. Brush button LED (fig. C, ref. 4), 2 quick flashes / pause / 2 quick flashes. Brush short circuit error. Brush short circuit error.
Contact customer service
Brush button LED (fig. C, ref. 4), 1 flash / pause / 1 flash Brush button LED (fig. C, ref. 4), 1 flash / pause / 1 flash. .
Overcurrent error Overcurrent error
Contact customer service
Suction button LED (fig. C, ref. 5), 2 quick flashes / pause / 2 quick flashes Suction button LED (fig. C, ref. 5), 2 quick flashes / pause / 2 quick flashes.
Suction short circuit error Suction short circuit error
Contact customer service
Suction button LED (fig. C, ref. 5), 1 flash / pause / 1 flash. Suction button LED (fig. C, ref. 5), 1 flash / pause / 1 flash.
Overcurrent error Overcurrent error
Contact customer service
Brush button LED (fig. C, ref. 4) + suction button LED (fig. C, ref. 5), synchronised flash Brush button LED (fig. C, ref. 4) + suction button LED (fig. C, ref. 5), synchronised flash
/ pause / synchronised flash. / pause / synchronised flash.
Electronic board temperature error Electronic board temperature error
Contact customer service
Brush button LED (fig. C, ref. 4), 4 quick flashes / pause / 4 quick flashes. Brush button LED (fig. C, ref. 4), 4 quick flashes / pause / 4 quick flashes. Brush motor thermal overload. Brush motor thermal overload.
Contact customer service
Battery charge yellow LED (fig. C, ref. 2), 7 quick flashes / pause / 7 quick flashes. Battery charge yellow LED (fig. C, ref. 2), 7 quick flashes / pause / 7 quick flashes. Machine on with battery charger Machine on with battery charger
powered error powered error
Contact customer service
Battery charge yellow LED (fig. C, ref. 2), 5 quick flashes / pause / 5 quick flashes. Battery charge yellow LED (fig. C, ref. 2), 5 quick flashes / pause / 5 quick flashes. Excess battery voltage. Excess battery voltage.
Contact customer service
33