IPC CT46, Operator'S Manual, Page: 27 / 34

EN
WARNING!
When using the Chem Dose system, the solution tank must be filled with WATER ONLY, at a temperature
of between 4 and 55 °C.
Do NOT put detergent solution into the tank
► ►
mount the most suitable brushes or pad drive mount the most suitable brushes or pad drive
boards for the floor and work to be performed; boards for the floor and work to be performed;
► ►
make sure that the squeegee is securely fastened and connected to the suction hose; check that the make sure that the squeegee is securely fastened and connected to the suction hose; check that the
front and rear blades are not worn. front and rear blades are not worn.
► ► adjust the working height of the squeegees. adjust the working height of the squeegees.
NOTICE NOTICE
If the machine is being used by an operator for the first time, it should be tried out initially in a spacious If the machine is being used by an operator for the first time, it should be tried out initially in a spacious
and obstacle-free area to acquire the necessary familiarity with the functions and controls. and obstacle-free area to acquire the necessary familiarity with the functions and controls.
Always empty the dirty water tank before filling the detergent tank again. Always empty the dirty water tank before filling the detergent tank again.
For effective cleaning and to extend the working life of the machine, For effective cleaning and to extend the working life of the machine,
follow a few simple rules:
►
prepare the work area by removing all possible obstacles;
►
begin working from the furthermost point to avoid walking on the area you have just cleaned;
►
choose the straightest possible working routes;
► divide large floors into parallel rectangular sections.
If necessary, finish off by passing a mop or rag rapidly over parts inaccessible to the scrubber dryer.
Working
After setting up the machine, proceed as follows:
►
mains powered versions : plug the machine into the mains power socket and press the main switch
(fig. C, ref. 8);
► battery-powered model with drive , activate the main switch (fig. D, ref. 6);
► lower the squeegee by means of the squeegee lever (fig. D, ref. 2);
► press the main switch (fig. C, ref. 3) (LED on);
► select the direction of travel (fig. D, ref. 4 - battery-powered model with drive only);
► set the percentage of detergent to be released by the Chem Dose (OPTIONAL) (fig. P, ref. 2).
► press the brush button (fig. C, ref. 4) “LED on”, this will also automatically activate suction and solution
flow. To extend machine operating time, the ECO function can be activated (see the paragraph “Con
-
trols - Descriptions”);
► press the brush lever (fig. D, ref. 1);
► adjust the speed of the machine by turning the potentiometer (fig. D, ref. 5 - battery-powered model
with traction drive only);
►
check regularly that detergent is reaching the brushes and top up if necessary;
► during cleaning operations, check the quality of the wash: if necessary, adjust the flow of detergent to
the brush using the detergent solution tap (fig. F, ref. 2) and adjust the percentage of detergent released
from Chem Dose (OPTIONAL) by turning the knob (fig. P, ref. 2).
WARNING!
Empty the dirty water tank each time you fill the detergent tank.
► The float switch (fig. H, ref. 1) in the dirty water tank turns suction off when the tank is full. If the switch
trips, stop work and empty the tank;
► battery models: if the red LED (fig. C, ref. 2) starts flashing, the batteries are nearly flat.
After a few After a few
seconds, the brush and suction motor shut down to prevent draining the batteries excessively. Charge seconds, the brush and suction motor shut down to prevent draining the batteries excessively. Charge
the batteries. the batteries.
27