IPC CT46, Operator'S Manual, Page: 22 / 34

EN
HANDLING AND INSTALLATION
Lifting and transporting the palletized machine
WARNING!
During all lifting operations, make certain the palletized machine is firmly secured to prevent it tipping
over or being accidentally dropped.
The machine must be loaded onto/unloaded from vehicles in areas with adequate lighting.
The machine is packaged on a wooden pallet by the Manufacturer. It must be loaded on to the transporting vehicle
using suitable equipment (see Directive 2006/42/EEC and subsequent amendments and/or additions). At destina
-
tion, it must be unloaded using similar means.
The palletized body of the machine can be lifted only with the aid of a fork lift truck. Handle with care to avoid
impact and ensure the machine is not overturned.
Inspection on delivery
When the carrier delivers the machine, make sure the packaging and machine are both whole and undamaged. If
the machine is damaged, make sure the carrier is aware of the damage and before accepting the goods, reserve
the right (in writing) to request compensation for the damage.
Unpacking
WARNING!
When unpacking the machine, the operator must be provided with the necessary personal protection
devices (gloves, goggles, etc.) to limit the risk of injury.
When unpacking the machine, proceed as follows:
►
cut and remove the plastic straps using scissors or nippers;
►
open the packaging;
► remove the machine from the pallet with the aid of a ramp (fig. L);
►
remove the bags included in the packaging and check the contents:
►
guarantee slip;
►
use and maintenance manual;
►
battery bridges with terminals (battery powered versions only); bridges with terminals (battery powered versions only);
► ►
extension power cable (mains powered version); extension power cable (mains powered version);
► ►
clean the outside of the machine in respect of safety regulations; clean the outside of the machine in respect of safety regulations;
► ► after unpacking the machine, install the batteries (battery versions) or connect the electrical connec
-
after unpacking the machine, install the batteries (battery versions) or connect the electrical connec
-
tions ( tions (
mains powered versions): see relevant sections.
The various items of packaging can be kept, if so desired, as these can be reused to protect the machine in the
event of it being moved to a different site or sent to a repair workshop.
If not retained, the packaging must be disposed of in compliance with current regulations.
Electrical connections and earth (mains powered versions)
The electrical characteristics of the machine are given on the rating plate. Make sure the frequency and voltage
correspond to those of the mains supply where the machine will be operated. As far as voltage is concerned,
models on which the rating plate specifies a voltage of 230 V can be used with voltages between 220 V and 240
V. Similarly, models rated at 115 V can be used between 110 V and 120 V. To avoid the risk of electrocution, only
use the extension cable supplied with the machine, which has an earth connection like that shown in the figure (fig.
O). Make sure that the machine is connected to a socket with the same configuration as the plug.
Do not use an adapter with this machine.
The frequency on the plate must always correspond to the mains voltage.
22