84
Parameter description
Parameter
Description
Number of Logs
It specifies the largest number of logs that can be displayed on the web UI.
Enable Log Service
It specifies whether to enable the log service function. This function is disabled
by default.
Log servers can be configured only if the log service function is enabled.
Log Server IP Address
It specifies the IP address of the log server.
To ensure that system logs can be sent to the log server, set the IP address,
subnet mask and gateway of the AP on the
Network Settings
>
LAN Setup
page to enable the AP to access the log server.
Log Server Port
It specifies the port (514 by default) used by the log service. It should be the
same port with the port configured by the log server.
Status
It specifies the status of the log server rule.
Operation
It specifies the operations you can perform on the log server:
−
Click
to modify the IP address, port, or status of the log server.
−
Click
to delete the target log server.
Add
Click it to add a log server.
Procedure for adding a log server
1.
To access the page, choose
Tools
>
Logs
and click
Log Settings
.
2.
Click
Add
.
3.
Set parameters as follows:
Summary of Contents for In-wall AP Series
