nano3G AP Installation Manual
Commission a nano3G AP
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011
Page 34
10)
Click
OK
to close and save the changes in each of the two dialogues. Also close
the Control Panel.
5.2
Start Up the AP
5.2.1
Start up a nano3G S4 or S8 AP
1)
To power up an S4 or S8, either.
• Use the power supply provided with the AP
or
• Connect a POE source to the splitter unit, then connect the short power
cable from the POE Splitter unit to the DC input on the AP
Note:
The AP may have been provided with only one of these options.
2)
Connect the commissioning terminal directly to the AP with an Ethernet cable.
5.2.2
Start up a nano3G E8 AP
1)
To power up a nano3G E8 AP, typically do one of the following:
• Connect a cable to carry POE+ from the injector to the LAN1 port on the AP,
then plug the POE+ injector into the mains
or
• Connect the optional power supply for the AP to the AP’s 12V DC input
2)
To establish an Ethernet connection between an E8 AP and the commissioning
terminal, do one of the following according to how the AP has been powered up:
• If using POE+ to power the AP, connect the Ethernet cable from the
commissioning terminal to the LAN input on the POE+ injector unit
or
• If not using POE+, connect the Ethernet cable from the commissioning
terminal directly to the LAN1 port on the AP
