Page 2
FLEX
CEILING
TILE
LED DRIVER AND ARRAY
COMPARTMENT
TBTS
LUMINAIRE HOUSING
CAUTION: Before installing, make certain A.C. power is off and the Test Switch Pilot Light (TSPL)
is disconnected.
STEP 2 -
WIRING TO THE LED LOAD AND NORMAL DRIVER
STEP 1 -
MOUNTING THE ILB-LP-CP-HE-SD-HV
STEP 3 -
INSTALLING THE TEST SWITCH PILOT LIGHT (TSPL)
The ILB-LP-CP-HE-SD-HV should be mounted on or nearby
the fixture above the ceiling. The flex conduit should be wired
into the driver/lamp compartment or to an electrical junction box
on the fixture which allows access to the fixture connections.
A. Locate a suitable location for the TSPL and
cable that is visible outside the fixture. Drill
or punch a 1/2” diameter hole in the fixture
wall or wireway cover. Insert the TSPL into
the hole so that the LED test button/pilot
light is located outside of the fixture.
B. Slide the TSPL Mounting Clip
firmly to lock and secure the
TSPL assembly.
C. Connect and fully engage the TSPL
Connector to the TSPL Socket.
Ensure the TSPL Connector is
properly seated in the TSPL Socket,
then mark the TSPL location on
the switch box plate with the TSPL
Label and apply the SD Status
Indicator Sticker.
INSTALLATION INSTRUCTIONS
Refer to the appropriate wiring diagram below. Make sure all connections are in accordance with NEC and any other
local requirements.
ILB-LP NORMAL DRIVER AND LED LOAD CONNECTIONS
ilbcp_tspl_normal-driver-and-load-only.eps
AC (NORMAL)
DRIVER
IOTA ILB-LP
EMERGENCY DRIVER
LED
LOAD
WHITE
WHT/RED
RED (+)
BLUE (-)
YELLOW
BROWN
LEDCODE (+)
LEDCODE (-)
VIOLET/WHITE (+)
LED INPUT(-)
LED INPUT (+)
LED OUTPUT (+)
LED OUTPUT (-)
!
Cap LEDCODE wires
if unused
TSPL
LUMINAIRE HOUSING
ILB-LP-CP-HE-SD-HV
FLEX
CEILING
TILE
LED DRIVER AND ARRAY
COMPARTMENT
TBTS
TSPL
ILB-LP-CP-HE-SD-HV
SPECIFICATIONS -
Illustration 1
MODEL
OUTPUT POWER
(CONSTANT)
MAX. CHARGE
AMPS
OUTPUT VOLTAGE
(MIN-MAX)
BATTERY
AMPS, MAX
CP10
CP15
10 WATTS
15 WATTS
0.213
0.211
15 - 55
20 - 55
1.20
1.04
0.08
0.09
0.10
0.11
NORMAL OPERATION
EMERGENCY OPERATION
INPUT AMPS
120 VAC
277 VAC
0.209
55-200
1.5
1.5
55-250
0.019
20 WATTS
CP20
CP30
30 WATTS
0.039
0.211
0.027
0.055
