INVT Goodrive20-EU VFD Series, Operation Manual

Page: 80 / 173

Goodrive20-EU Series VFD Function parameters
-75-
Function
code
Name Description Default Modify
P08.06
Jog running
frequency
This parameter is used to define the reference
frequency during jogging.
Setting range: 0.00Hz
–P00.03 (the max.
frequency)
5.00Hz
○
P08.07
Jogging
running
acceleration
time
The jogging acceleration time means the time
needed if the VFD runs from 0Hz to the max.
frequency.
The jogging deceleration time means the time
needed if the VFD goes from the max. frequency
(P00.03) to 0Hz.
Setting range: 0.0
–3600.0s
Depend
on
model
○
P08.08
Jogging
running
deceleration
time
○
P08.09
Jumping
frequency 1
When the set frequency is in the range of
jumping frequency, the VFD will run at the edge
of the jumping frequency.
The VFD can avoid the mechanical resonance
point by setting the jumping frequency. The VFD
can set three jumping frequency. But this
function will be invalid if all jumping points are 0.
Set frequency f
Time t
Jump
frequency 2
1/2*Jump
frequency range 2
1/2*Jump
frequency range 2
Jump
frequency 1
1/2*Jump
frequency range 1
1/2*Jump
frequency range 1
Jump
frequency 3
1/2*Jump
frequency range 3
1/2*Jump
frequency range 3
Setting range: 0.00
–P00.03 (the max. frequency)
0.00Hz
○
P08.10
Jumping
frequency
range 1
0.00Hz
○
P08.11
Jumping
frequency 2
0.00Hz
○
P08.12
Jumping
frequency
range 2
0.00Hz
○
P08.13
Jumping
frequency 3
0.00Hz
○
P08.14
Jumping
frequency
range 3
0.00Hz
○
P08.15 Traverse range This function applies to the industries where
traverse and convolution function are required
such as textile and chemical fiber.
The traverse function means that the output
frequency of the VFD is fluctuated with the set
frequency as its center. The route of the running
frequency is illustrated as below, of which the
0.0%
○
P08.16
Sudden
jumping
frequency
range
0.0%
○
P08.17
Traverse boost
time
5.0s
○