En
23
23
1 – Switch the digital receiver off using the main power switch on the rear panel.
2 – Connect the digital receiver to the PC using a RS232 cable.
3 – In the terminal software of the PC, open a communication port with following parameters: 115200bps, 8bit,
1stop bit, no parity and no flow control.
4 – Select the new software file to send to the unit and set the protocol to 1k X modem.
5 – Start sending the file.
6 – Switch on the digital receiver to start the loading procedure.
During the transfer, the receiver will display the message “OTC” with a progress bar. After the file has been
received and unpacked, the digital receiver will update the current software and automatic restart. All user
preferences and channel lists will remain unchanged.
SOFTWARE UPDATE VIA USB
The software can be updated using a USB mass storage device.
To update the software using a USB mass storage device, you will require the new software file from our website
and a USB device, such as a USB hard disk or memory stick.
a)
Copy the software bin file to the root folder of the USB mass storage device.
b)
Turn the receiver on and allow it to boot up.
c)
From the Settings Menu, select System Information.
d)
Insert the USB mass storage device into the USB slot on the front panel of the receiver.
e)
The message “USB – Mounting” will appear at the top of the screen. After it changes to “USB – Init:
OK” it is ok to proceed.
f)
If a compatibility statement appears, press “OK” and proceed to the next step.
g)
Select Software Update and press “OK.” Press the “Green” function key on the remote for “Yes” to
start the download and press “Yes” again to confirm.
After the file has been installed and unpacked, the receiver will update the current software and automatically
restart. All user preferences and channel lists will remain unchanged.
Caution:
Be careful not to interrupt the software installation by removing the USB stick, turning off the receiver,
or otherwise interrupting the installation process. If the installation is interrupted by accident, such as by a
power failure, the receiver may not boot up afterwards. If so, you can recover normal operation by installing new
software using the RS232 connection, or by returning the receiver for service.
Note:
Installation of a complete software bundle, including boot loader, will reset all user settings and erase the
channel list. The library will remain unchanged.
Media Manager
The Media Manager is where all of the channel lists are organized:
