1EnIDL5000HD-print.fh10 1/18/06 12:53 PM Page 8
Composite
C
M
Y
CM
MY
CY CMY
K
4.2 Output Mode Selection
After you have connected the AV cables for video and audio between your digital receiver and the display
device, check that the position of the output selection switch is correct for your chosen connection method
as in the table below.
Switch Position
A
B
C
Video Output Format
YPbPr
RGB
TV / CVBS
Receiver Mode
SD / HD
HD
SD
Switch on the digital receiver and the display device, and select
the correct AV input on the display device. The digital receiver
will take about 10 seconds to switch on. You may now start the
installation procedure.
The installation procedure is used to set up the video formats
that may be output from the digital receiver to the display device.
4.2.1 Installation Format Selection
Use the Remote Control keypad to perform the digital receiver
format testing and installation. Follow the digital receiver’s on-
screen instructions to do the installation.
4.2.2 Mode A (SD/HD, YPbPr
)
The switch on the rear of the digital receiver must be in position
A, and the AV connections must be taken from the YPbPr RCA
sockets. The digital receiver display will show “HdcI”. Press
“Ok” to confirm the selection, or switch to another mode.
Proceed to INSTALLATION.
4.2.3 Mode B (HD, RGB)
The switch on the rear of the digital receiver must be in position
B, and the AV connections must be taken from the RGB HD15
socket. The digital receiver display will show “Hd r”. Press “Ok”
to confirm the selection, or switch to another mode. Proceed to
INSTALLATION.
4.2.4 Mode C (SD, CVBS)
The switch on the rear of the digital receiver must be in position
C, and the AV connections must be taken from the CVBS TV
RCA socket. The digital receiver display will show “Sdtv”. Press
“Ok” to confirm the selection, or switch to another mode. Proceed
to INSTALLATION.
