![Inverto IDL-5000HD User Manual Download Page 7](http://html1.mh-extra.com/html/inverto/idl-5000hd/idl-5000hd_user-manual_2085168007.webp)
1EnIDL5000HD-print.fh10 1/18/06 12:53 PM Page 7
Composite
C
M
Y
CM
MY
CY CMY
K
4. Installing Your Receiver
4.1 Connections to the satellite antenna
4.1.1 Cable connection
Connect the dish cable to the HD receiver LNB IN connector.
Also connect the cable between your analogue receiver LNB
IN and RF OUT connector on the rear of the receiver.
(Refer to A)
4.1.2 Video Connections
Adjust switch on the rear panel according to the format supported
by your display device, and it contains three modes:
A, B and C
4.1.2.1 Mode A (SD/HD, YPbPr)
Connect the YPbPr component video output socket on your
digital receiver to your display device’s YPbPr component video
input. Be sure to match the colours on the RCA sockets with
the coloured plugs. (Refer to B)
Note: When unit is in Mode A, there is no video output from the
CVBS TV socket.
4.1.2.2 Mode B (HD, RGB)
Connect the D-sub socket to your display device. (Refer to C)
Note: Cable is not supplied.
4.1.2.3 Mode C (SD, TV / CVBS)
Connect the CVBS composite video output socket on your digital
receiver to your TV’s CVBS video input socket.
Connect the S-Video (Y/C) component video output socket on
your receiver to your TV’s S-Video input socket. (Refer to D)
Note: Cable is not supplied.
Note: When unit is in Mode C, there is no output from the
YPbPr sockets.
4.1.3 Audio Connections
If your TV set is equipped with Dolby Digital and/or MPEG audio
decoding
capability, you may connect the Digital Audio output
by Optical or Coaxial RCA socket on your receiver to TV Digital
Audio input Optical or Coaxial RCA socket. (Refer to E) You
may also connect the digital audio output to your A/V receiver
assuming it is capable of decoding Dolby Digital /MPEG digital
audio stream.
If your TV set and/or A/V receiver does not support Dolby
Digital/MPEG decoding, you need to connect L/R Audio output
RCA sockets on your receiver to stereo L/R Audio inputs of TV
set and/or A/V receiver. (Refer to F). If your A/V receiver supports
Dolby Pro Logic decoder, you can switch ON
“Downmix-Surround” function.
(B) Mode A
(C) Mode B
(D) Mode C
(A)
(E)
(F)