Invacare ROZE, Assembly Instructions Manual

Page: 2 / 12

Roze™ Patient Lift Liftarm Assembly
2
Part No 1160830
Hardware Replacement Kit
Overview
The following checklist provides an overview of the procedures necessary to replace the hardware
contained in this kit.
❑
Remove the electric actuator.
❑
Remove the liftarm assembly.
❑
Install liftarm assembly.
❑
Install the electric actuator.
Removing/Installing the Electric Actuator
NOTE: For this procedure, refer to FIGURE 1 on page 3.
1. Unplug the electric actuator from the control box on the mast assembly. Thread the actuator lead through
the actuator lead routing hole in the mast assembly.
2. Remove the hardware that secures the top of the electric actuator to the lift arm actuator mounting
bracket.
A. Remove the rubber caps from the nut and screw that attach the electric actuator to the lift arm
actuator mounting bracket.
B. Remove the screw, washer, bearing, nylon washer, actuator cap, bushing, nylon washer, bearing,
washer, flat washer and nut.
NOTE: The actuator cap will become loose when the attaching hardware is removed. Inspect the actuator cap for
damage. Replace the actuator cap if damage is found.
3. Remove the hardware that secures the bottom of the electric actuator to the mast assembly actuator
mounting bracket.
A. Remove the rubber caps from the nut and screw that attach the electric actuator to the mast assembly
actuator mounting bracket.
B. Remove the screw, washer, bearing, nylon washer, bushing, nylon washer, bearing, washer, flat
washer, and nut.
4. To install the electric actuator, reverse STEPS 1 ‐ 3.