Part No. 1114817 - Rev.B
5
Personal Back10
FIGURE 4 - INSTALLING THE SIDE PLATES
6.CLOSE the cane clamps around the back cane and use two (2) cap nuts to secure the
mounting hardware to the back cane. Hand tighten.
7.Repeat STEPS 1-6 to install remaining set of mounting hardware onto the opposite back
cane.
8.Ensure the side plates are mounted to the back canes at the same height and are parallel to
each other.
9.Using the wrench supplied, securely tighten the Personal Back10 mounting hardware.
INSIDE OF WHEELCHAIR
Mark
Back Cane
Cane Clamps
(OPEN Position)
Mounting
Bolts
Side Plate (Inside)
Side Plate Mounting
Holes (Lower)
Side Plate Mounting
Holes (Upper)
Cane Clamp
Mounting Holes
Cap Nut
Mounting
Slot(s)
Cane Clamps
(OPEN Position)
Cap Nut
NOTE: Left Back cane shown.